Table of Contents
Advertisement
6.
Inspect the tires; refer to
(page
35).
Raising the Stabilizer Legs
End-Dump Models Only
End-dump models have a front stabilizer leg and 2
rear stabilizer legs.
Raise the stabilizer legs before towing the machine.
1.
Adjust the machine so that there is no weight
resting on the rear stabilizer legs.
2.
Pull the clevis pin out from 1 of the rear stabilizer
legs and the bracket
Figure 18
Inspecting the Tires
(Figure
19).
Figure 19
3.
Slide the stabilizer leg up in the bracket and
align the pin hole of the bracket with the lower
hole in the stabilizer leg
4.
Push the clevis pin through the hole in the
bracket and the stabilizer leg
5.
Repeat steps
stabilizer leg.
6.
Lift upward on the tongue so that there is no
weight resting on the front stabilizer leg.
7.
Pull the clevis pin out from the front stabilizer leg
and the tongue
g019741
1. Remove the clevis pin.
2. Rotate the stabilizer leg
up.
8.
Rotate the front stabilizer leg up into the tongue
(Figure
20).
9.
Push the clevis pin through the rearward hole in
the tongue and the front stabilizer leg
20).
g019917
17
(Figure
19).
(Figure
1
through
4
for the other rear
(Figure
20).
Figure 20
3. Install the clevis pin.
19).
g019915
(Figure
Advertisement
Table of Contents
