Zone Or Zone/Address (H2/B1) - Panasonic EBL512 G3 Operating Instructions Manual

28.1. ZONE OR ZONE/ADDRESS (H2/B1)

When a whole zone is disabled, all alarm points within the zone will be disabled except the addressable manual call points.
Alarm points can be individually disabled.
DISABLE:
a) Log on to the c.i.e.
b) Navigate to menu B1
c) Press the soft key
- Zone 000
- Zone 000 address 00
- Zone 000 address 00 `Smoke only`.
d) If "Automatically re-enablement" shall be used, time press
e) Press to disable.
RE-ENABLE:
f) Use the to toggle between:
- Disable
- Re-enable list
g) Select "Re-enable list".
h) Press to select the Zone or Zone / Address to be re-enabled.
i) Press to re-enable. Re-enabled zone or zone / address will disappear from the list, indicated with a beep.
The sensor values for disabled analog smoke detectors in NORMAL mode will not be used for calculation
of the week average sensor value, i.e. only the values saved before and after the disablement will be used
for this calculation.
to toggle between:
Change type of disablement
and . Insert time (hh:mm). Default is current time + 3 hours.
90