Installing The Shoulder Bolt (Rm5010-Hybrid Only) - Toro Verticutter Reelmaster 5010 Series Operator's Manual

Figure 5
1. Cap screws
2. Straight grease fitting
(install)
2. Install the straight grease fitting
3. If there are no bolts on the reel-motor side-plate,
install them (Figure
4. Install the O-ring on the reel motor
Note:
The electric motor is shown; this step
also applies to the hydraulic motor.
Figure 6
1. O-ring
3. Setscrew (remove and
discard)
(Figure 5).
5).
(Figure
4
Installing the Shoulder Bolt
(RM5010–Hybrid only)
Parts needed for this procedure:
5 Shoulder bolt
Procedure
For verticutters being mounted on a Reelmaster
g028407
5010-H, replace the shoulder bolt on the reel-motor
side-plate (Figure
otherwise, the electric reel will contact the existing
bolt.
6).
1. Old bolt
g027164
7
7) with the new shoulder bolt;
Figure 7
2. New shoulder bolt
g029157