Setup; Inspecting The Verticutter - Toro Verticutter Reelmaster 5010 Series Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
Media and Additional Parts
Description
Operator's Manual
Parts Catalog (not included)—refer to the
included postcard for information on obtaining
the Parts Catalog
Note:
Determine the left and right sides of the
machine from the normal operating position.
1

Inspecting the Verticutter

Parts needed for this procedure:
1 Verticutter
Procedure
After the verticutter is removed from the box, inspect
the following:
1. Check each end of the reel for grease. Grease
should be visibly evident in the internal splines
of the reel shaft.
2. Ensure that all nuts and bolts are securely
tightened.
Description
Verticutter
Transport roller assembly
Cotter pin
O-ring
Straight grease fitting
Shoulder bolt
End-weight kit (sold separately)
No parts required
No parts required
Qty.
1
2
2
1
1
5
1
–
–
Qty.
1
Review the material and save it in an appropriate place.
–
3. Make sure that the carrier frame suspension
operates freely and does not bind when moved
back and forth.
5
Use
Inspect the verticutter.
Install the transport rollers.
Install the O-ring and the grease fitting.
Install the shoulder bolt
(RM5010–Hybrid only)
Install the end-weight kit (Model 03618
only).
Adjust the verticutter.
Mount the verticutter reel.
Use