Product Overview; Specifications; Operation; Training Period - Toro Verticutter Reelmaster 5010 Series Operator's Manual

Product Overview

Specifications

Model
03618
03619
Net weight
With no end weight:
49.4 kg (109 lb)
With small end weight
(hydraulic motor):
52.6 kg (116 lb)
With large end weight
(electric motor):
55.8 kg (123 lb)
59.9 kg (132 lb)
9

Operation

Training Period

Before operating the verticutter reels, evaluate the
performance of the reel at the desired setting. Operate
in a clear, unused area to determine if the desired
results will be achieved. Adjust as desired.

Adjusting the Verticutter

Adjusting the Blade Depth
Note:
The maximum recommended blade
penetration depths are as follows:
•
Model 03618 is 3 mm (1/8 inch).
•
Model 03619 is 6 mm (1/4 inch).
1. Place the verticutter reel on a level surface.
2. Place 2 gauge bars, which have the desired
depth of blade penetration below the ground,
under the front and rear rollers of the verticutter
reel on each end of the reel
1. Gauge bars
Note:
The verticutter blades must not touch the
gauge bars.
3. Turn the adjusting bolt on each height-of-cut
bracket (Figure 9) so that the verticutter blades
come in contact with the level surface on both
ends.
Note:
As the verticutter blades wear, the
diameter of the reel will decrease and the depth
setting will change. Check the depth setting
periodically to ensure that the desired setting is
achieved.
(Figure 9).
Figure 9
2. Adjusting bolts
g346209