Table of Contents
Advertisement
3
Installation
3.1 Appropriate location
for installation
In order to prepare the product for use, refer the
information in the user manual and ensure that
electrical installation and water installation are
appropriate. If not, call a qualified electrician and
technician to have any necessary arrangements
carried out.
B
WARNING:
be held liable for damages that may
arise from procedures carried out by
unauthorized persons.
B
WARNING:
in during installation. Otherwise, there is
the risk of death or serious injury!
WARNING:
room where the product shall be placed is
A
so tight to prevent passing of the product,
remove the door of the room and pass the
product through the door by turning it to
its side; if this does not work, contact the
authorized service.
• Place the product on a level floor surface to
prevent jolts.
• Install the product at least 30 cm away from
heat sources such as hobs, heater cores and
stoves and at least 5 cm away from electrical
ovens.
• Product must not be subjected to direct sun light
and kept in humid places.
• Your product requires adequate air circulation to
function efficiently. If the product will be placed
in an alcove, remember to leave at least 5 cm
clearance between the product and the ceiling,
rear wall and the side walls.
• If the product will be placed in an alcove,
remember to leave at least 5 cm clearance
between the product and the ceiling, rear
wall and the side walls. Check if the rear wall
clearance protection component is present at
its location (if provided with the product). If the
component is not available, or if it is lost or
fallen, position the product so that at least 5 cm
Manufacturer shall not
Product must not be plugged
: If the door clearance of the
clearance shall be left between the rear surface
of the product and the wall of the room. The
clearance at the rear is important for efficient
operation of the product.
• Do not install the product in places where the
temperature falls below -5°C.
3.2 Installing the plastic wedges
Plastic wedges supplied with the product are
used to create the distance for the air circulation
between the product and the rear wall.
1. To install the wedges, remove the screws on the
product and use the screws supplied together with the
wedges.
2. Insert the 2 plastic wedges onto the rear ventilation
cover as illustrated in the figure.
9 / 37 EN
Refrigerator / User Manual
Advertisement
Table of Contents
