Adjusting The Tracking Of The Traction Control, Full Forward Position - Toro 22322 Operator's Manual

WARNING
When the traction unit is running, you could
be caught and injured in moving parts or
burned on hot surfaces.
Stay away from pinch points, moving parts,
and hot surfaces when adjusting the running
traction unit.
5. If the left track moves, lengthen or shorten the right
traction rod until the track stops moving.
6. If the right track moves, lengthen or shorten the left
traction rod until the track stops moving.
7. Tighten the jam nuts.
8. Close the rear-access cover.
9. Shut off the engine and lower the traction unit to the
ground.
10. Drive the traction unit in full reverse, checking to
see if the unit tracks straight. If it does not, note the
direction the traction unit veers. Repeat the adjustment
previously described so that it tracks straight in reverse.
Adjusting the Tracking of the
Traction Control, Full Forward
Position
If the traction unit does not drive straight when you hold
the traction control against the reference bar, complete the
following procedure:
1. Drive the traction unit with the traction control against
the reference bar, noting which direction the traction
unit veers.
2. Release the traction control.
3. If the traction unit veers to the left, loosen the right
jam nut and adjust the tracking set screw on the front
of the traction control
4. If the traction unit veers to the right, loosen the left
jam nut and adjust the tracking set screw on the front
of the traction control
1. Set screw
2. Jam nut
5. Repeat steps 1 through
straight in the full forward position.
Important: Ensure that the tracking set screws
touch the stops in the full forward position to avoid
over stroking the hydraulic pumps.
40
(Figure 57).
(Figure 57).
Figure 57
3. Stop
4 until the traction unit drives