Using The Cylinder Lock; Using Attachments - Toro 22322 Operator's Manual

Using the Cylinder Lock

WARNING
The loader arms may lower when in the raised
position crushing anyone under them.
Install the cylinder lock before performing
maintenance that requires raised loader arms.
Installing the Cylinder Lock
1. Remove the attachment.
2. Raise the loader arms to the fully raised position.
3. Shut off the engine.
4. Remove the lynch pin securing the cylinder lock to the
loader arm (Figure
G004182
1. Cylinder lock
2. Lift cylinder
5. Lower the cylinder lock over the cylinder rod and
secure it with the lynch pin
6. Slowly lower the loader arms until cylinder lock
contacts the cylinder body and rod end.
Removing/Storing the Cylinder Lock
Important: Ensure that the cylinder lock is removed
from the rod and fully secured in the storage position
before operating the traction unit.
1. Start the engine.
2. Raise the loader arms to the fully raised position.
3. Shut off the engine.
4. Remove the lynch pin securing the cylinder lock.
5. Rotate the cylinder lock up to the loader arm and
secure it with the lynch pin.
6. Lower the loader arms.
19).
1
Figure 19
3. Lynch pin
(Figure 19).

Using Attachments

Important: If you are using an attachment with a
serial number of 200999999 or earlier, the manual for
the attachment may contain information specific to the
use of the attachment with other traction units, such as
settings for the flow divider control and speed selector
lever and the use of a counterweight on the traction unit.
These systems are built into the TX, and you should
ignore any references to them.
Installing an Attachment
Important: Use only Toro-approved attachments.
Attachments can change the stability and the operating
characteristics of the traction unit. The warranty of the
traction unit may be voided if used with unapproved
attachments.
Important: Before installing the attachment, ensure
that the mount plates are free of any dirt or debris and
that the pins rotate freely. If the pins do not rotate freely,
grease them.
1. Position the attachment on a level surface with enough
space behind it to accommodate the traction unit.
2. Start the engine.
3 3. Tilt the attachment mount plate forward.
4. Position the mount plate into the upper lip of the
attachment receiver plate
2
1. Mount plate
5. Raise the loader arms while tilting back the mount plate
at the same time.
Important: The attachment should be raised
enough to clear the ground, and the mount plate
should be tilted all the way back.
6. Shut off the engine.
20
(Figure 20).
Figure 20
2. Receiver plate