Toro 22322 Operator's Manual page 38

Figure 50
1. Spring-removal tool
2. Drive belt
3. Idler pulley spring (spring
cover not shown)
4. Remove the idler pulley spring from the idler-pulley
assembly (Figure 51).
4. Idler pulley
5. Engine (see-through for
illustrative purposes)
Spring cover not shown
1. Idler-pulley assembly
5. Remove the belt from the 3 pulleys
Spring cover not shown
6. Install a new drive belt around the 3 pulleys
7. Install the end of the idler pulley spring to the arm on
the idler-pulley assembly.
Important: If you have removed the spring cover,
ensure to install it over the spring at this time.
8. Using the spring-removal tool, pull the idler spring
hook up and around the stud on the traction unit,
pulling the idler pulley tight.
9. Remove the spring-removal tool from the spring and
close the hood.
38
Figure 51
2. Drive-belt routing
(Figure 52).
Figure 52
(Figure 51).