Replacing The Power Supply Assembly - Lenovo 10KY Hardware Maintenance Manual

Table of Contents

Advertisement

Note: When the computer is turned on for the first time after replacing the coin-cell battery, an error
message might be displayed. This is normal after replacing the coin-cell battery.
12. Use the Setup Utility program to set the date, time, and any passwords. See "Using the Setup Utility
program" on page 57.

Replacing the power supply assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
Although there are no moving parts in your computer after the power cord has been disconnected, the
following warnings are required for your safety and proper Underwriters Laboratories (UL) certification.
CAUTION:
Hazardous moving parts. Keep fingers and other body parts away.
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a problem with
one of these parts, contact a service technician.
To replace the power supply assembly, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the computer cover. See "Removing the computer cover" on page 82.
3. Remove any parts that might prevent your access to the storage drive bracket. Depending on your
computer model, you might have to remove the optical drive or the storage drive in the optical drive bay.
See "Replacing the optical drive" on page 82 or "Replacing the storage drive" on page 85.
4. Remove the storage drive in the primary storage drive bay. See "Replacing the storage drive" on page 85.
5. Locate the power supply assembly. See "Computer components" on page 31.
6. Disconnect the power supply assembly cables from the system board. See "Parts on the system
board" on page 34.
96
Lenovo S510 Hardware Maintenance Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

S51010l010lb10lc10lf10lg

Table of Contents