Replacing The Coin-Cell Battery - Lenovo 10KY Hardware Maintenance Manual

7. From inside the chassis, pivot the upper retaining clip
sensor downward and then push the clip outward. Then, disengage the plastic holder holding the
thermal sensor from the chassis.
Figure 28. Removing the thermal sensor
8. Pull the entire thermal sensor out of the chassis.
9. Insert the connector and cable of the new thermal sensor into the lower hole
align the two tabs on the plastic holder holding the thermal sensor with the two holes
chassis, and push the plastic holder until it snaps into position.
Figure 29. Installing the new thermal sensor
10. Reconnect the thermal sensor cable to the system board. See "Parts on the system board" on page 34.
11. Reinstall the front bezel. See "Replacing the front bezel" on page 84.
12. Reinstall the optical drive. See "Replacing the optical drive" on page 82.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 110.

Replacing the coin-cell battery

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
94
Lenovo S510 Hardware Maintenance Manual
1 that secures the plastic holder of the thermal
1 in the chassis. Then,
1 and 2 in the