Canon imagePRESS P400 Service Manual page 68

14. Flip the service switches to normal mode (both switches set to OFF).
For an illustration of the service switch modes, see Figure 26.
IMPORTANT:
If you do not remove the USB flash drive (step 13) and do not flip the service switches to normal mode (step 14), when the
imagePRESS Server is starting up, it will try to copy the files again from the USB, and cause the imagePRESS Server start
up to fail.
15. Reconnect the cables to the imagePRESS Server (see
• Connect the network cable between the imagePRESS Server and the customer network.
• Connect the crossover Ethernet cable between the imagePRESS Server and the printer.
NOTE:
Be sure to use the correct cable for each connection.
16. Make sure that the imagePRESS Server power switch is in the ON (|) position.
17. Power on the printer using the main power switch.
Allow the imagePRESS Server to start up and reach Idle (00 should appear on the imagePRESS Server LED display).
NOTE:
If you press the Fiery icon on the printer touch panel before the imagePRESS Server finishes the startup process, "TCP connect
error" appears on the printer touch panel. Press OK to return to the Home screen, and wait until the imagePRESS Server reaches
Idle.
18. After seeing "Perform Apply Setting Changes from Settings/Registration." displayed on the host machine's Touch
Panel, select [Apply Set. Changes] > [Yes].
19. If you saved a configuration file earlier, restore the system configuration (see
on page 50).
NOTE:
If it was not possible to save a configuration file or if you installed an upgraded version of system software, you must configure
Setup using the Configuration pages you printed earlier. For information about performing Setup, see Configuration and Setup,
which is part of the user documentation set. Bypass any settings if it is more appropriate for the site administrator to set them.
After you exit Setup and allow the system to reboot, ask the site administrator to restore the custom files that were archived earlier.
20. After seeing "Perform Apply Setting Changes from Settings/Registration." displayed on the host machine's Touch
Panel, select [Apply Set. Changes] > [Yes].
21. Install any required software patches:
• If you reinstalled the same version of system software, be sure to reinstall all software patches that were previously
installed on the imagePRESS Server. For a list of installed patches, see the Configuration pages that you printed earlier.
• If you installed an upgraded version of system software (for example, version 1.0 to version 2.0), contact your authorized
service/support center for a list of valid software patches. Some or all of the patches listed on the Configuration pages
that you printed earlier may no longer be valid. Before installing a patch, be sure to verify with your authorized service/
support center that it is valid for your system version. Installing an invalid patch may result in system corruption.
22. Reconnect any USB devices that you may have removed earlier.
23. If the imagePRESS Server requires a static IP address (for example, in a non-DHCP network environment), work with
the network administrator to configure it (see the Configuration and Setup which is part of the user documentation).
■ Install the system software through network connection
Using the Fiery Installer Builder you can install the system software stored on a network location. All the data on the HDD and
the configuration information will be lost, make sure to create a backup of the data or system configuration.
4. INSTALLING SYSTEM SOFTWARE
"imagePRESS Server hardware" on page
"Restoring the system configuration"
62
16):