Canon imagePRESS P400 Service Manual page 29

2. To release a DIMM, push the lever outward on each side of the DIMM.
No.
1 DIMM
2 Lever
3 DIMM slot
4 Slot notch
3. Pull the DIMM straight out of the slot.
4. To replace a DIMM, insert the DIMM into the slot and press the DIMM straight down into the slot so that the levers
lock the DIMM into place.
NOTE:
DIMMs fit in the slots only one way. The notch on the bottom of each DIMM should line up with the notch in the slot.
Make sure that the levers close securely around the ends of the DIMM and that the DIMM is fully seated in its slot.
5. Reassemble the imagePRESS Server and verify its functionality (See
after service" on page
6. If you installed a new DIMM and cleared the CMOS, configure the time and date in Setup (See
date and time" on page
■ Motherboard
This section describes the battery and default jumper settings on the imagePRESS Server motherboard, as well as procedures
for removing and replacing the motherboard.
If you are replacing the motherboard with a new one, ask the site administrator for the passphrase to unlock the Fiery User Data
Encryption.
By unlocking the encryption, the new motherboard can read the imagePRESS Server user data stored on the HDD.
The default passphrase for User Data Encryption is the Fiery password printed on the Configuration Page.
For details, see "Obtain the default password" on page
The site administrator can change the passphrase using Configure WebTools (by selecting Security > User Data Encryption.
● Motherboard battery
The battery is located on the motherboard.
NOTE:
Spare batteries are not available through your authorized service/support center. To replace the battery, use a 3V manganese
dioxide lithium coin cell battery (Panasonic CR2032 or equivalent).
Figure 8: Releasing a DIMM
43)
25).
13.
Item
"Restoring imagePRESS Server functionality
23
3. REPLACING PARTS
"Configure the system