Advertisement
Preparing the Cutting Units
1.
Release the cutting unit from the arm by
removing the 24 mm locknut and plain washer
from the cutting unit pivot pin. Refer to the
relevant machine Operator's Manual.
2.
Remove the cutting unit from the pin.
Note:
It is not necessary to disconnect the
cutting unit hydraulic hoses during this stage.
3.
Remove the fasteners and bushings that hold
the fixed cutting unit casting in position on top of
the cutting unit and remove the casting.
Note:
All fasteners and removed components
should be retained throughout the conversion
process. Once the kit is fully fitted, any parts left
over can be discarded.
4.
Before assembling the float/pivot casting to
the cutting unit, ensure that the bushings are
pushed fully into their bores, and that the grease
fittings are installed securely.
Figure 2
g196882
2
Advertisement
