Greasing The Machine; Product Overview; Specifications; Attachments/Accessories - Toro Groundsmaster 3200 Series Operator's Manual

1. Jam nuts
2. U-bolt
7. Adjust the nuts (Figure
rear of the cutting unit so that the tips of the rear
blades are 6 to 10 mm (1/4 to 3/8 inch) higher
than the front tips.
8. Tighten the jam nuts.
6

Greasing the Machine

No Parts Required
Procedure
Before operating the machine, it must be greased
to ensure proper lubricating characteristics; refer
to Greasing the Bearings and Bushings (page
Failure to properly grease the machine will result in
premature failure of critical parts.
Figure 6
3. Height-of-cut chain
6) to raise or lower the

Product Overview

Specifications

Note:
Specifications and design are subject to
change without notice.
•
Width
of Cut
•
Height Adjustable from 25 to 152 mm (1 to 6 inches) in 13
of Cut mm (1/2 inch) increments
•
Net
Weight
•
g296783

Attachments/Accessories

A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
18).
11
Model No. 39190: 1.52 m (60 inches)
Model No. 31972: 1.82 m (72 inches)
Model No. 31970: 204 kg (450 lb)
Model No. 31972: 238 kg (525 lb)
www.Toro.com for a list of all