Setup - Toro Groundsmaster 3200 Series Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
WARNING
If you leave the key in the switch, someone could accidentally start the engine and seriously
injure you or other bystanders.
Remove the key from the switch before you install the cutting unit
DANGER
If the engine is started and the PTO shaft is allowed to rotate, serious injury could result.
Do not start the engine and engage the PTO switch when the PTO shaft is not connected
to the gearbox on the cutting unit.
Note:
Determine the left and right sides of the machine from the normal operating position.
Description
No parts required
No parts required
Hex-head bolt
Washer
Height-of-cut pin
Shoulder bolt
Spacer
No parts required
No parts required
Qty.
–
Prepare the machine.
–
Install the CE kit (if required).
2
2
Install the cutting unit to the traction unit.
2
2
Install the PTO cover.
2
–
Level the cutting unit.
–
Grease the machine.
8
Use