3-3. SE-1142 Board
1. Remove the cabinet. (Refer to Section 1-5.)
2. Remove the MD general assembly (DC). (Refer to Section 3-2.)
3. Disconnect the two harnesses from the connectors (CN201 and CN202) on the SE-1142 board.
4. Remove the screw, then remove the SE-1142 board.
5. To install, reverse the removal procedure.
n
Remove the slack of the harness connected from the SE-1143 board on the side of the SE-1142 board.
(Refer to Section 3-4.)
6. Perform the check (self-diagnosis). (Refer to Section 3-15.)
UP-D898DC
CN202
CN201
BVTT2.6
5
SE-1142 board
Harnesses
3-3 (E)