Table of Contents
Advertisement
1-7. Firmware Version Upgrade
1. Start the utility software. (Refer to Section 1-6.)
2. Click the [GET] button of "Firmware Version" of the Version Up tab.
The version of the firmware currently installed in this unit is displayed.
3. Write down the current firmware version.
4. Click the [EXEC] button of "Send VUP File".
5. Select the firmware (vup) file, and then click the [OPEN] button.
After the file is transferred, the firmware writing is started.
The display of during the firmware writing is as follows.
. UPGRADE (blinks), ON/STANDBY LED (Blinks in green.): Information is being written in flash
. REBOOT (lights up), ON/STANDBY LED (Lights in green.): Writing is completed.
When the firmware writing is completed, 3 beep sounds are made.
n
When the ON/STANDBY switch is turned off during the firmware writing, the unit becomes standby
state after the firmware writing is completed.
6. Check that the writing is completed, and then restart this unit.
7. Click the [GET] button of "Firmware Version" of Version Up tab.
8. Check that the firmware is upgraded to the latest version.
UP-D898DC
[GET] button
[EXEC] button
memory ROM (IC402/MA-201
board).
1-21 (E)
Advertisement
Table of Contents
