Applicable Standards - ABB ACSM1 Hardware Manual

Disposal

Applicable standards

• EN 50178 (1997)
• IEC 60204-1 (2005),
modified
• EN 60529: 1991
(IEC 60529)
• IEC 60664-1 (2007), Edition
2.0
• IEC 61800-3 (2004)
• EN 61800-5-1 (2003)
• UL 508C (2002), Third
Edition
• NEMA 250 (2008)
• CSA C22.2 No. 14-05
(2005)
The regen supply module contains raw materials that should be recycled to preserve
energy and natural resources. The package materials are environmentally compatible and
recyclable. All metal parts can be recycled. The plastic parts can either be recycled or
burned under controlled circumstances, according to local regulations. Most recyclable
parts are marked with recycling marks.
If recycling is not feasible, all parts excluding electrolytic capacitors and printed circuit
boards can be landfilled. The DC capacitors contain electrolyte, which is classified as
hazardous waste within the EU. They must be removed and handled according to local
regulations.
For further information on environmental aspects and more detailed recycling instructions,
please contact your local ABB distributor.
The regen supply module complies with the following standards, provided that only
ACSM1-04 drives (frame sizes A-D) are used with them. The compliance with the
European Low Voltage Directive is verified according to standards EN 50178 and
EN 60204-1.
Electronic equipment for use in power installations
Safety of machinery. Electrical equipment of machines. Part 1: General requirements.
Provisions for compliance: The final assembler of the machine is responsible for installing
- an emergency-stop device
- a supply disconnecting device
- the ACSM1-204 into a cabinet.
Degrees of protection provided by enclosures (IP code)
Insulation coordination for equipment within low-voltage systems. Part 1: Principles,
requirements and tests.
Adjustable speed electrical power drive systems. Part 3: EMC requirements and specific
test methods.
Adjustable speed electrical power drive systems.
Part 5-1: Safety requirements. Electrical, thermal and energy
Provisions for compliance: The final assembler of the machine is responsible for installing
the ACSM1-204 in a cabinet that is protected to IP2X (IP3X for top surfaces for vertical
access). Approval pending.
UL Standard for Safety, Power Conversion Equipment.
Enclosures for Electrical Equipment (1000 Volts Maximum)
Industrial Control Equipment. Approval pending.
77
Technical data