Compliance With The Machinery Directive; C-Tick Marking; Compliance With Iec 61800-3 (2004); Ul Marking - ABB ACSM1 Hardware Manual

80
1. It is ensured that no excessive emission is propagated to neighbouring low-voltage networks. In
some cases, the natural suppression in transformers and cables is sufficient. If in doubt, a supply
transformer with static screening between the primary and secondary windings can be used.
2. An EMC plan for preventing disturbances is drawn up for the installation. A template is available from
the local ABB representative.
3. The motor cables are selected as specified in the chapter Planning the electrical installation in the
ACSM1-04 Drives Hardware Manual.
4. The DC and control cables are selected as specified in the chapter
installation.
5. The regen supply module is installed according to the instructions given in this manual.

Compliance with the Machinery Directive

The regen supply module is intended to be incorporated into machinery to constitute machinery
covered by Machinery Directive (98/37/EC) and does therefore not in every respect comply with the
provisions of the directive. For more information, see the Declaration of Incorporation by ABB Drives
(code 6884199).

C-Tick marking

See the type designation label for the valid markings of your drive.
C-Tick marking is required in Australia and New Zealand. A C-Tick mark is attached to the drive to
verify compliance with the relevant standard (IEC 61800-3 (2004) – Adjustable speed electrical power
drive systems – Part 3: EMC product standard including specific test methods), mandated by the Trans-
Tasman Electromagnetic Compatibility Scheme.
The Trans-Tasman Electromagnetic Compatibility Scheme (EMCS) was introduced by the Australian
Communication Authority (ACA) and the Radio Spectrum Management Group (RSM) of the New
Zealand Ministry of Economic Development (NZMED) in November 2001. The aim of the scheme is to
protect the radio frequency spectrum by introducing technical limits for emission from electrical/
electronic products.

Compliance with IEC 61800-3 (2004)

See page 78.

UL marking

See the type designation label for the valid markings of your regen supply module.
Technical data
Medium voltage network
Neighbouring network
Point of measurement
Low voltage
Equipment
(victim)
Equipment
Supply transformer
Static screen
Low voltage
Supply module
Equipment
Planning the electrical