Mounting The Drag Mat Carrier To The Traction Unit - Toro Sand Pro 3040 Manual

2. If you are installing the coconut-fiber mat, drill a hole
(3/8 inch) in the mat at each clamp location, using the
mat retainer as a template
Figure 7
1. Drag-mat carrier
2. Bolt—3/8 x 1 inch (11)
3. Mat retainer (11)
4. Drill a hole (3/8 inch) here.
3. For either mat, secure the edge of the mat to the drag
mat carrier as shown in
inch), mat retainers, and flange nuts (3/8 inch).
4. Wrap the mat under the drag mat carrier and repeat
steps 1 through 3 for the front edge of the carrier using
the remaining mounting hardware.
5. If you will be using the drag mat carrier on a golf green,
remove the skid located on each side of the carrier
frame (Figure 8).
Note: Using the steel mat is not recommended on
golf greens.
(Figure 7).
5. Align the edge of the mat
to the rear edge of the
carrier.
6. Coconut-fiber mat
7. Flange nut—3/8 inch (11)
Figure 7, using 5 bolts (3/8 x 1
1. Drag-mat carrier side
2. Skid
3
Mounting the Drag Mat Carrier
to the Traction Unit
No Parts Required
Procedure
1. Remove any attachment from the rear of the machine.
2. Lower the traction-unit adapter. Back the traction unit
into position in front of the attachment adapter.
Note: Make sure that the locking lever is pivoted to
the left (unlocked position) as viewed from the rear
of the machine.
3. Slide the attachment adapter onto the adapter on the
traction unit.
Note: Position the long leg of the lift-arm assembly
under the rear frame of the traction unit
6
Figure 8
3. Bolt
4. Nut
(Figure 9).