Table of Contents
Advertisement
SETTING UP THE UNIT
WHERE TO USE THE UNIT
Keep at least 10 cm away from the wall.
Approx. 195 cm
Approx.
Width
30 cm
approx. 80 cm
Approx.
35 cm
Area where legrest
Area where unit
could touch the floor
touches the floor
1 UNPACK THE UNIT AND RAISE THE BACKREST
CAUTION
•
When raising the backrest, do not allow hands or feet to become caught between the backrest and the backrest
latch or the backrest and the armrests.
Failure to follow this precaution may result in pinching, which may lead to injury.
Backrest latch
Check that there
is nothing
around the unit.
2 INSPECT CONTENTS OF SHIPPING CONTAINER
Massage Lounger
Pillow
Back Cushion
Armrests — 2
5
5-6
•
Avoid places where the unit will be exposed to direct sunlight
for long periods of time or places where it will be exposed to
high temperatures, such as in front of a heater, etc., as this
can cause discoloration or hardening of the synthetic leather.
•
Placing a mat or cloth under the unit is recommended to
prevent floor damage. The size of the mat should be sufficient
(at least 10 cm × 70 cm) to cover the areas where the unit
touches and where the legrest could touch the floor.
•
Set the unit near the outlet.
See Warning No. 10 and 1 on page 1.
Mat
1
Remove the top of the shipping container.
•
When packed for shipping the backrest is folded forward.
2
Remove the packing and cushioning
materials and take out the accessories.
3
Raise the backrest.
•
Do not connect the power cord to an electrical outlet during setup.
•
Hold the backrest with both hands and lift in the direction of the
arrow until it comes to a stop.
•
Be careful to avoid catching the power cord or the controller cord.
Allen Key — 1
Lock Switch Key — 1
Attachment Screws — 8
•
The lock switch key has
been inserted in the lock
switch prior to leaving the
factory.
Power cord
3 HOW TO MOVE THE UNIT
Using the wheels to move the unit
•
Grasp the legrest to move the unit when using the wheels.
•
It is easier to move the unit with the massage heads
retracted and the backrest in the upright position.
* Place a mat or cloth on the floor and move the unit slowly
to prevent floor damage.
Move it slowly
Legrest
Wheels
4 INSTALL THE ARMRESTS ON THE UNIT
Back
1
Zipper
Front
Left
Convex
Round hole
Front
Rear
2
Lift up
Secure with
screws
Allen key
Front
Rear
3
4
Lifting the Unit
•
Move the unit by having one person hold the legrest and
another person use the handles on the back.
* Please hold the handles and legrest securely to avoid
dropping the unit as it may damage your floor.
Place your
fingers to the
handle
Install the armrests.
(Be careful to avoid damaging the coated fabric.)
1 Unfasten the zipper of the armrest completely.
2 Check the side (right or left) of the armrest. Check the
direction (front or back) of the armrest as well.
The illustration shows the left armrest. The right armrest is
stamped "Front", "Right" and "Back".
* The left armrest must be installed on the left hand side of the
unit.
3 Align the convex portion of the armrest with the round hole
on the unit, and embed the armrest on the unit. Avoid
catching the coated fabric between them.
If it is caught, pull it out without damaging the fabric.
Secure the armrests with attachment screws.
(Total of positions for a single armrest)
Lift the coated fabric on the side of the armrest and insert the
attachment screw onto the end of the Allen key, and then tighten.
(Tighten the screws in the positions lightly at first, and then
tighten all screws firmly.)
* If the screw does not enter into the hole, tighten the screw by
pushing the armrest from the top.
* When tightening attachment screws 1 and 3, inserting the
screws while pushing the covering and inside urethane of the
armrest up with your thumb will make them easier to tighten.
* When tightening attachment screw 2, reclining the backrest will
make it easier to tighten.
Close the zipper at the bottom side of the
armrests.
When closing the zipper, be careful not to twist the end of the
zipper.
1 Set the zipper.
2 Fasten the zipper.
Put both ends of the zipper into the inside.
Turn in the edge of the zipper.
6
2010/07/09
11:16:37
Advertisement
Table of Contents
