Table of Contents
Advertisement
5 FIX THE CONTROLLER CORD
Fix the controller cord with the fastener for securing the controller cord at a position
about 45 cm from the connected part of the controller on either the right or left side
of the armrest.
* Confirm that there is a margin for the controller cord length when the backrest is reclined.
(The illustration shows that the cord is attached to the right armrest.)
Approx. 5 cm
6 ATTACHING THE BACK CUSHION AND PILLOW
7 CONNECT THE POWER CORD TO THE UNIT
1
Appliance inlet
Power
Connector
switch
2
section
3
Power cord
BEFORE USING THE UNIT
1 CHECK THE SURROUNDING AREA
2 CHECK THE POWER CORD AND THE POWER PLUG
See Warning No. 7 on page 1.
3 BE SURE TO PUSH THE CONNECTOR ALL THE WAY INTO THE APPLIANCE INLET
7
7-8
1
Attach the back cushion using the zipper.
2
Attach the pillow using the fasteners.
Check for dirt and damage on appliance inlet
of the power switch section and the connector
of the power cord.
Insert the connector into the appliance inlet.
Be sure to push the connector in all the way.
Make sure there are no objects, people, or pets in the vicinity of
the unit.
4 SWITCHING ON THE POWER SUPPLY
1
1
2
3
2
3
5 CHECK THE UNIT
3
1
Make sure the covering is free of rips or tears.
2
Make sure there are no obstacles between
the parts of the unit.
1
3
Make sure the massage heads are in the
retracted position, i.e. they are parked to the
4
left and right in the upper part of the backrest.
If not retracted, press
retracted position.
4
Make sure the legrest is lowered.
•
Do not sit on the legrest when it is raised. Doing so may cause it to
collapse down or bend the legrest. The legrest is not meant to
support full body weight.
See Warning No. 8 on page 1 and No. 7 and 1 on page .
6 ADJUSTING FOR CORRECT PILLOW HEIGHT
Fasteners
Adjust the pillow height so that the bottom
edge of the pillow is at ear level.
•
If positioned too low, the pillow can lessen the effect of massage around
the neck area.
Fasteners
7 ADJUSTING THE RECLINING ANGLE
Press
and
to adjust the angle of the backrest and legrest.
•
With either button held down, movement will continue until a "beep-beep-beep" sound indicates the legrest or backrest has
been raised or lowered as far as possible.
•
The legrest will start to move shortly after the backrest.
Approx. 80˚
Approx. 0˚
* The reclining operation is a function that adjusts the angle of the backrest and legrest. Avoid using it for any other purposes,
such as continuous up/down operation etc.
Insert the power plug into an electrical
outlet.
Turn the lock switch key to the "open"
position.
Slide the power switch to the "on"
position.
twice to return the massage heads to the
Approx. 120˚
Approx. 170˚
8
2010/07/09
11:16:38
Advertisement
Table of Contents
