Samsung AG010KSV Series Installation Manual page 7

Wiring must be connected with the designated
wires and it must be fixed securely so that it does
not apply any external force to the connection part
of the terminals.
If connection or fixation is not properly done, it
may cause heat generation or fire.
Please connect ground wire.
If the ground wire is not properly fixed, there is
potential risk of electric shock or fire.
Do not connect the grounding cable to a gas
pipe, water pipe, lightening conductor or the
grounding cable of the telephone.
CAUTION
Drain system must be constructed according to this
installation manual so that condensation water
drains properly, and drain system should be kept
warm to prevent dew condensation.
When water management is not done properly,
water leakage may occur and cause property
damage.
Install the power cable and communication cable
of the product at least 5 ft away from the electric
appliances and install it at least 6.6 ft away from
the lightning conductor.
Even if the cables are installed more than 6.6 ft
away from electronics, noise can be generated
from them depending on the status of the
electric wave.
Do not leave any obstacles around the inlet and
outlet of the product.
It may cause product failure or other accidents.
Do not install the product in following places.
A place where noise and warm air of the product
may disturb neighbors
- It may cause property loss.
A place full of mineral oil, place where oil
scatters or with oil vapors such as a kitchen
- Plastic parts may get damaged and cause
water leakage, or maybe even cause product
to fall down.
- The performance of the heat exchanger may
decrease or cause product failure.
A place near exhaust pipes or ventilation outlet
where corrosive gas such as ammonia gas or
sulfurous acid gas are being generated
- Copper pipe and connection parts may corrode
causing refrigerant leakage.
A place with a machine that generates
electromagnetic waves
- Electromagnetic waves may cause problems in
control system and product may not operate
normally.
A place where there is a danger of combustible
gas leakage or the place where thinner or
gasoline is handled
- There is a risk of fire or explosion.
A place with airborne carbon fiber or flammable
dust
A place near seashore or hot spring where there
is risk of product corrosion
Install MCCB for each product.
Use ELCB that has harmonic wave prevent
function since the product uses inverter
compressor.
It may cause electric shock or fire if more than
two products are installed on one MCCB.
Make sure to install drain pipe for draining
performed correctly.
If the installation is not done properly,
water leakage may occur and cause product
malfunction.
Wear protective equipment (such as safety gloves, goggles,
and headgear) during installation and maintenance works.
Installation/repair technicians may be injured if protective
equipment is not properly equipped.
7
English