Cub Cadet ZTX6 60 Operator's Manual page 10

3. Remove the hex cap screw and sems nut securing the red positive battery
lead to the positive battery post (marked POS).
4. Carefully lift the battery out of the tractor.
5. Install the battery by repeating the above steps in the reverse order.
Charging the Battery
Test and, if necessary, recharge the battery after the tractor has been stored for a
period of time.
• A voltmeter
Voltmeter
or load tester
Reading
should read
12.6 volts (DC)
12.7
or higher across
12.4
the battery
terminals. See 12.2
Figure 19.
12.0
• Charge the
battery with a
12-volt battery
charger at a
MAXIMUM rate of 10 amps.
Operating the Seat Latch
1. Place the lapbar drive
control levers fully out in
the parking brake position.
2. Locate the seat latch at the
rear base of the seat.
3. Press downward on the
front tabs to disengage the
seat latch.
4. Rotate the entire seat pan
upward. See Figure 20.
Adjusting the Seat
1. Push left and hold the seat
adjustment lever
to adjust the
seat position.
2. Slide seat forward
or rearward to
desired position.
3. Release the
adjustment
lever. Ensure seat
is locked into
position before
operation. See
Figure 21.
ASSEMBLY
State of Charging
Charge Time
100% Full Charge
75% 90 Min.
50% 180 Min.
25% 280 Min.
Figure 19
Figure 20
Figure 21
10
Adjusting the Mechanical Suspension Mechanism (ZT6
Models Only)
The mechanical suspension
mechanism (if equipped)
incorporates weight/ride
adjustment controls for operators
in the 125 to 275 lb. (57-124 kg)
weight range. Turn the knob on
the front of the seat clockwise to
increase the weight capacity and
counter-clockwise to decrease.
See Figure 22.
NOTE: The seat base must be
secured by the latch, otherwise, the seat assembly could tilt forward. The Operator
Presence Sensor must be connected to the electrical wiring harness.
Figure 22