Sfp Status - GE JungleMUX SONET Technical Practice

Rate: In Use
Displays the rate and duplex mode set for this RJ-45 port.
possible readings are:
- 10M HDX
- 10M FDX
- 100M HDX
- 100M FDX
Note: When devices on the LAN do not support auto-negotiation and
the ETHER-1000 unit‟s auto-negotiation is enabled, the unit uses the
highest speed, but in half-duplex mode.
Xover: Allow
Applicable to multi-port paddleboard ports only. May be set to:
Auto
MDI
MDIX
Note: The "Auto" feature functions regardless of whether the far-end
device is set to "Auto".
Xover: In Use
For a multi-port paddleboard port, this field may display:
MDI
MDIX

SFP Status

This frame is active only if the selected port is an optical port on an SFP device.
The information displayed in this frame (see Figure 41) is collected through the
transceiver‟s diagnostic monitoring interface (DMI).
Manufacturer Name
Displays the name of the SFP transceiver‟s manufacturer.
Manufacturer Part# / Revision
Displays the part number that the transceiver‟s manufacturer uses for
this device. The transceiver‟s revision number is also displayed.
Fiber
Displays the type of fiber (smf = single-mode fiber, or mmf = multimode
fiber) that the transceiver shall be used with.
Copyright  GE Multilin Inc. 2010-2012
10Base-T, Half Duplex
10Base-T, Full Duplex
100Base-TX, Half Duplex
100Base-TX, Full Duplex
Auto-sensing for MDI/MDIX mode is enabled. The user
can connect to any device regardless of the type of RJ-45
cable used (straight-through or crossover).
The port is forced to MDI mode
The port is forced to MDIX mode
The port is in MDI mode (auto-sensed or forced)
The port is in MDIX mode (auto-sensed or forced)
342-86400-498PS
Issue 1.2
April 2012
Page 102
The
Note that smf