Table of Contents
Advertisement
2. If the card is successfully installed and found by the operating system, you will see a message
similar to the following. Note that for each card, there will be two physical functions found:
one for management and one for user. See
details.
02:00.0 Memory controller: Xilinx Corporation Device 5048
Subsystem: Xilinx Corporation Device 000e
Physical Slot: 1
Flags: bus master, fast devsel, latency 0, IRQ 26, NUMA node 0
Memory at f0000000 (64-bit, prefetchable) [size=128M]
Memory at f8000000 (64-bit, prefetchable) [size=128K]
Capabilities: [40] Power Management version 3
Capabilities: [48] MSI: Enable- Count=1/1 Maskable- 64bit+
Capabilities: [60] MSI-X: Enable- Count=32 Masked-
Capabilities: [70] Express Endpoint, MSI 00
Capabilities: [100] Advanced Error Reporting
Capabilities: [180] Alternative Routing-ID Interpretation (ARI)
Capabilities: [1c0] #19
Capabilities: [3a0] #25
Capabilities: [600] Vendor Specific Information: ID=0020 Rev=0
Len=010 <?>
Kernel driver in use: xclmgmt
Kernel modules: xclmgmt
02:00.1 Memory controller: Xilinx Corporation Device 5049
Subsystem: Xilinx Corporation Device 000e
Physical Slot: 1
Flags: bus master, fast devsel, latency 0, IRQ 68, NUMA node 0
Memory at f8020000 (64-bit, prefetchable) [size=64K]
Memory at e0000000 (64-bit, prefetchable) [size=256M]
Capabilities: [40] Power Management version 3
Capabilities: [48] MSI: Enable- Count=1/1 Maskable- 64bit+
Capabilities: [60] MSI-X: Enable- Count=32 Masked-
Capabilities: [70] Express Endpoint, MSI 00
Capabilities: [100] Advanced Error Reporting
Capabilities: [180] Alternative Routing-ID Interpretation (ARI)
Capabilities: [600] Vendor Specific Information: ID=0020 Rev=0
Len=010 <?>
Kernel driver in use: xocl
Kernel modules: xocl
Confirm Firmware Installation
When a card has successfully been installed and the firmware has been updated, both entries for
Platform and the satellite controller (SC) version installed on the card and the system must
match. If they do not match, the system will be unable to correctly run applications on your card.
To confirm they match, run the following command and visually compare the 'Platform' and 'SC
Version' entries under Flashable partitions running on FPGA and Flashable
partitions installed in system match. See
to obtain the device management BDF.
$ sudo /opt/xilinx/xrt/bin/xbmgmt examine --device <management BDF>
UG1531 (v1.0) March 4, 2022
VCK5000 Hardware Install Guide
Chapter 5: Card Bring-Up and Validation
XRT and Vitis™ Platform Overview
Appendix C: Obtaining Card BDF Values
Send Feedback
for additional
www.xilinx.com
22
Advertisement
Table of Contents
