Table of Contents
Advertisement
Changing XRT and Target Platform
Versions
The VCK5000 data center accelerator card target platform and XRT revisions can change
significantly between releases. To ensure a successful migration to a newer or older version of
the VCK5000 card XRT and platform, carefully follow the instructions for your specific release
pairing. Failure to adhere to these procedures can result in an unstable installation or other
issues. In general, it is recommended to use the latest available versions which contain bug fixes
and the newest features.
Note: For links to the available platform and XRT revisions, see
Software.
IMPORTANT! Do not enter Ctrl + c in the terminal while the firmware is flashing as this can cause the
card to become inoperable.
RedHat and CentOS
During upgrading, downgrading, or uninstalling, it can be useful to list the currently installed
VCK5000 packages. To list the currently installed deployment platform package, run the
following command in a Linux terminal:
$ yum list installed | grep xilinx
To list the currently installed XRT package, run the following command:
$ yum list installed | grep xrt
Installing Newer Packages
Install the newest XRT and deployment platform on your VCK5000 card by following these
steps. Currently, both packages must be upgraded concurrently.
1. Download the desired XRT and deployment platform packages and follow installation in
and Deployment Platform Installation Procedures on RedHat and
UG1531 (v1.0) March 4, 2022
VCK5000 Hardware Install Guide
Appendix B: Changing XRT and Target Platform Versions
Chapter 4: Installing the Deployment
Send Feedback
Appendix B
XRT
CentOS.
www.xilinx.com
35
Advertisement
Table of Contents
