Transporting The Machine - Toro GreensPro 1260 Operator's Manual

Transporting the Machine

1. Drive the machine to the transport vehicle.
2. Engage the parking brake.
3. Move the throttle lever to the low-speed position, and
allow the engine to run for 10 to 20 seconds.
4. Turn the On/Off switch to the O
5. Turn the fuel-shutoff valve to the C
6. Raise the machine onto the transport wheels as follows:
A. Push up on the hitch assembly until the latch lever
is unlocked from the slide detent
Figure 25
1. Latch lever
B. Lift the latch lever so that it slides freely, and pull
the hitch down.
Figure 26
C. Step on the hitch pedal until the hitch locks into
place (Figure 27).
position.
FF
position.
LOSED
(Figure 25).
23
1
2
Figure 27
1. Hitch pedal
D. Insert the locking pin
7. Lower the machine onto the rollers as follows:
A. Remove the locking pin
1
Figure 28
1. Locking pin
B. Lift up on the hitch assembly to tip the machine
up slightly.
C. Push down on the hitch latch to unlatch the hitch
(Figure 28).
G024197
2. Locking pin
(Figure 27).
(Figure 28).
2
G024199
2. Hitch latch