Huawei FusionDC1000A Manual page 92

FusionDC1000A Prefabricated All-in-One Data
Center
Product Description (IT Scenario)
Item
BLINK
button
Indicators
Table 6-27 AC actuator indicators
Indica
tor
Power
RUN
ALM
RF_Z
Issue 01 (2021-04-20)
Specifications
● Press the button for less than 1 second to start blinking.
● Hold down the button for 1–5 seconds to search for a network
and start networking.
● Hold down the button for more than 6 seconds to clear
network parameters.
Col Name
or
Gre Power status
en indicator
Gre Running
en status
indicator
Red Alarm
indicator
Gre Communicati
en on status
indicator
Copyright © Huawei Technologies Co., Ltd.
Status Description
Steady on The power input is normal.
Off There is no power input.
Off The power is abnormal or the
board program is loading.
Blinking at The AC actuator successfully
long intervals registers with the ECC800-Pro
and the software runs properly
(the indicator blinks at 0.5 Hz,
on for 1s and then off for 1s).
Blinking at The communication fails or the
short AC actuator fails to register
intervals with the ECC800-Pro (the
indicator blinks at 4 Hz, on for
0.125s and then off for 0.125s).
Blinking The indicator blinks at super
short intervals for 0.5s (blinking
at 10 Hz, on for 0.05s and then
off for 0.05s) and then turns off
for 0.5s. The cycle lasts for 10s.
Steady on A system failure alarm is
generated.
Off No system alarm is generated.
Steady on No network parameters exist,
or a network is to be created.
Blinking at A network is set up, and no
long intervals node access is allowed (the
indicator blinks at 0.5 Hz, on
for 1s and then off for 1s).
6 Management System
85