Ac Actuator - Huawei FusionDC1000A Manual

FusionDC1000A Prefabricated All-in-One Data
Center
Product Description (IT Scenario)
Item
DI input
RS485 serial
port
expansion
Wiegand
port
BLINK
button
Address DIP
switch
E-label

6.6 AC Actuator

The AC actuator is used in a pre-fab. module to receive upstream instructions for
controlling lights or fans. The AC actuator can connect to the ECC800-Pro
controller by wireless networking (802.15.4).
Issue 01 (2021-04-20)
Specifications
One DI input port for connecting to the door status switch
Two RS485 ports (one route) with the default communication
rate of 9600 bit/s, physical port cascading function reserved
Two Wiegand ports, 12 V DC card reader operating power output;
two routes of card readers can operate at the same time.
● Press the button for less than 1 second to start blinking.
● Hold down the button for 1–5 seconds to search for a network
and start networking.
● Hold down the button for more than 6 seconds to clear
network parameters.
4-pin address DIP switch
Supported
Copyright © Huawei Technologies Co., Ltd.
6 Management System
83