Advertisement
LSSS Preparation
The sensor input board must be installed in the next
available slot in the satellite. For example, with a 16 station
satellite, the sensor input board must be located at the
17-32 station board location. If all slots are filled, the last
station output board must be removed.
The LSSS board has 8 output stations on it. If your
satellite was originally a 64-station satellite, you
are replacing the last 8 stations with sensor inputs.
The empty slot might end up being on the back side
of the controller. If that is the case, purchasing
additional hardware might be necessary. Talk to your
authorized Toro distributor.
If there are multiple empty slots available, the sensor
input board must be installed in the next available
slot after the station output boards.
Toro supplies a sticker to label the final 8 stations in your
system. For example, if your satellite has one station
output board (16 stations), the sensor board would include
stations 17 through 24 and the 17 through 24 station label
should be applied.
1. Peel appropriate station number sticker
adhesive backing. Apply to station count area.
2. Apply the sensor sticker
Sensor Input Board Installation
1. Remove the front panel door and power down
the satellite controller.
2. Locate the next available output board slot
in which to install the sensor input board. If
the satellite is utilizing all output board slots,
remove the last station output board and use
that location.
3. Insert the sensor input board
1
top port
lines up with the distribution
board port.
2
4. Install the fuse
then connect power to
3
power connector
5. Secure with the included screws
6. If a Surge Board is not already available, install
the provided Surge board
Secure with four retaining screws
7. Depending on the 8 stations from the
LSSS board, insert the appropriately labelled
plastic tab bar
C
into the holes in the surge
board
.
B
For an explanation of the text on the
plastic tab bar, see table and illustration
next page.
8. Restore power to the satellite controller. The
satellite should detect and display the correct
number of stations and 7 sensor inputs. Note
the station count; this value will be used to
update the satellite station count in Lynx.
2
A
from
B
to the sensor sticker area.
so that the
A
.
4
.
.
B
.
5
A
3. Use a black marker to "black out" the sensors that are
NOT part of the system.
2
5
C
17 18 19 20 21 22 23 24 I1 I2 I3 I4 I5 I6 G 12V
B
3
1
A
5
4
B
Advertisement
