Reference Edit; How To Edit Reference Value - ABB ACSM1 Control Panel User Manual

42

Reference Edit

In the Reference Edit option, you can:
• accurately control the local reference value,
• start, stop, change the direction and switch between local and remote control.
Editing is allowed only in the LOC state, the option always edits the local reference
value.

How to edit reference value

Step Action
1. If the panel is in the remote control mode (REM shown on the status line),
switch to local control (LOC shown on the status line) by pressing
Reference editing is not possible in remote control mode. The display shows a
message about that, if you try to enter REF EDIT in the remote control mode.
2. Otherwise, go to the Main menu by pressing
mode, otherwise by pressing
3. Go to the Reference Edit option by selecting REF EDIT on the menu with keys
and
4. Select the correct sign with keys
correct numbers with keys
selected, press
number you are editing moves on to the next one on the right.
5. After the last number is selected, press
EXIT
pressing
Operation
EXIT
repeatedly until you get to the Main menu.
ENTER
, and pressing .
and
NEXT
. If you do not select a number for a couple of seconds, the
. The selected reference value is shown in the status line.
MENU
if you are in the Output
NEXT
and , and press
, and after each number is
SAVE
. Go to the Output mode by
REM MESSAGE
Reference editing
LOC .
REM
enabled only in
local control mode
LOC MAIN MENU
TIME & DATE
PAR BACKUP
REF EDIT
EXIT
LOC REF EDIT
+
0000.00
CANCEL
. Select the
LOC REF EDIT
-
1250.00
CANCEL
LOC
DIR
Display
00:00
5
00:00 ENTER
rpm
00:00 NEXT
rpm
00:00 SAVE
-1250.00rpm
49. 10
Hz
0. 50
A
10. 7
%
00:00 MENU