Engine - Toro 30363N Operator's Manual

A. Remove the battery terminals from the battery
posts.
B. Clean the battery, terminals, and posts with a wire
brush and baking soda solution.
C. Coat the cable terminals and battery posts with
Grafo 112X skin-over grease (Toro Part No.
505-47) or petroleum jelly to prevent corrosion.
D. Slowly recharge the battery for 24 hours every 60
days to prevent lead sulfation of the battery.

Engine

1. Drain the engine oil from the oil pan and replace
the drain plug.
2. Remove and discard the oil filter. Install a new filter.
3. Refill the engine with 4 quarts (3.8 l) of recommended
motor oil. Refer to Changing the Engine Oil.
4. Start the engine and run it at idle speed for two
minutes.
5. Drain the fuel from the fuel tank, fuel lines, pump,
filter, and separator. Flush the fuel tank with clean
diesel fuel and connect all fuel lines.
6. Thoroughly clean and service the air cleaner
assembly.
7. Seal the air cleaner inlet and the exhaust outlet with
weather proof masking tape.
8. Check the oil filler cap and fuel tank cap to ensure
they are securely in place.
61