Premaintenance Procedures; Lubrication; Greasing The Bearings And Bushings - Toro 30363N Operator's Manual

CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Premaintenance
Procedures
Important: The fasteners on the covers of this
machine are designed to remain on the cover after
removal. Loosen all of the fasteners on each cover a
few turns so that the cover is loose but still attached,
then go back and loosen them until the cover
comes free. This will prevent you from accidentally
stripping the bolts free of the retainers.
Figure 39
Service Interval Chart

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. If the machine is operated under normal
conditions, lubricate all bearings and bushings after
every 50 hours of operation. Bearings and bushings
must be lubricated daily when operating conditions are
extremely dusty and dirty. Dusty and dirty operating
conditions could cause dirt to get into the bearings
and bushings, resulting in accelerated wear. Lubricate
the grease fittings immediately after every washing,
regardless of interval specified.
1. Wipe the grease fittings clean so foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into the fittings.
3. Wipe off excess grease.
Figure 40 and Figure 41 illustrate the locations of the
grease fittings.
36