Table of Contents
Advertisement
network connection and setup
3.
In the <Address> pane, provide the
necessary information.
MAC (Ethernet) Address : The MAC
(Ethernet) address of the applicable
network encoder will be set auto-
matically so you don't need to input it
manually.
If using a Broadband Router
IP Address : Enter an address falling in
the IP range provided by the Broadband
Router.
ex) 192.168.1.2~254,
192.168.0.2~254,
192.168.XXX.2~254
Subnet Mask : The <Subnet Mask> of
the Broadband Router will be the <Sub-
net Mask> of the network encoder.
Gateway : The <Local IP Address> of the Broadband Router will be the <Gateway>
of the network encoder.
M
The settings may differ depending on the connected Broadband Router model.
For more information, refer to the user manual of the applicable router.
Refer to the "Port Range Forward (Port Mapping) Setup" section of the Broadband Router's
documentation. (Page 31)
If not using a Broadband Router
For setting <IP Address>, <Subnet Mask>, and <Gateway>, contact your network administrator.
4.
In the <Port> pane, provide
necessary information.
HTTP Port : Used to access the
network encoder using the Internet
browser, defaulted to 80. Use the
spin button to change the HTTP Port
value.
VNP Port : Used to control the video
signal transfer, defaulted to 4520.
5.
Enter the password.
This is the login password for the "admin" user who accesses the network encoder.
The default password is "4321".
28_ network connection and setup
Advertisement
Table of Contents
