Table of Contents
Advertisement
8/68
Bosch Rexroth AG
Safety instructions
2
Safety instructions
2.1
About this chapter
The mMS 4.0 training system has been manufactured in accordance with
the general rules of technology. Nevertheless, there is the danger of personal
injury or property damage if this chapter and the safety instructions in this
documentation are not observed.
Read this documentation fully and thoroughly before you work with
the mMS 4.0 training system.
Keep the documentation in a place where there are available to all users
at any time.
Whenever passing on the Training system to third parties, include the required
documentation.
2.2
Intended use
The mMS 4.0 training system is a mechanical and electrical system with
pneumatics and/or hydraulics systems.
It may only be used to impart knowledge and expertise of advanced technical
education in the high-level programming language area and control engineering.
With respect to the set-up of whole assemblies and simulations, only the devices
and device sets are only used for the mMS 4.0 training system.
Operation is only permitted under the indicated operating conditions.
The mMS 4.0 training system is only intended for professional and not
for private use.
The mMS 4.0 training system made by Bosch Rexroth has been designed and
is intended for industrial power supply networks. Supplying the demo system
from different supply network requires additional disturbance suppression
measures (line filter, throttles, etc.).
Intended use also includes having thoroughly read and understood the safety
regulations, product information and operating instructions below, in particular,
the "Safety instructions".
2.3
Improper use
Any other use than that described under intended use, is not intended use and
is therefore not authorized.
If unsuitable products are installed in safety-relevant applications, unintended
operating states may arise in the application which could cause personal injury
and/or property damage. Therefore, only use the product in safety-relevant
applications if such a use is specified and allowed in the product documentation.
For example in explosion-protected areas or in safety-relevant parts of a control
(functional safety).
Bosch Rexroth AG cannot assume liability for damage in the event of improper use
of the product. The user is solely responsible for the risks due to improper use.
Training system mMS 4.0 | R901429162/04.16
Advertisement
Table of Contents
Troubleshooting
