Bosch REXROTH mMS 4.0 Operating Manual page 51

Training system mMS 4.0 | R901429162/04.16
Entire installation (3 Stations)
The following aspects must be satisfied to operate the entire installation:
The transfer connectors for signals and emergency stop circuit must

be connected to both the stations on the right and left.
With the first and last station, the terminating connectors must be plugged

into the transfer connectors for signals and emergency stop circuit as for
the individual stations.
If not, plug the terminating connector/-socket into the transfer module.

The emergency stop circuit of the installation is not closed until the terminating

connector/socket are plugged into the transfer connector and the stations
are connected to each other.
Fig. 25: Connecting the transfer and terminating connectors
The power supply connectors must be connected to the left-hand station.

With the left-hand station, the connection cable must be connected to the

current cable with an earthing-pin plug and can be connected to 110-230V AC.
Fig. 26: Connecting the power supply
Bosch Rexroth AG
Set-up, installation and commissioning
51/68