Product- And Technology-Dependent Safety Instructions - Bosch REXROTH mMS 4.0 Operating Manual

12/68 Bosch Rexroth AG
Safety instructions
2.6

Product- and technology-dependent safety instructions

High electrical voltage
Danger to life, danger of injury due to electrical shock or severe injury!
Always de-energize the installation.

Secure the installation against being switched on accidentally.

Do not operate a device terminal box or sockets which are not connected

to the power supply (fuse boxes) of the mMS 4.0 training system. All of the
components not powered by the device's own electrical control boxes, but
using components (in use) installed in the mMS 4.0 training system are
unaffected by an EMERGENCY STOP circuit (and OFF switch). The mains
voltage continues to apply in the electrical control box.
Do not open the electrical control box. If opening is necessary, only have

the electrical control box open by a qualified electrician.
When connecting additional consumers to the mMS 4.0 training system, only

use ones approved by the manufacturer.
Only operate the mMS 4.0 training system from a supply with a functioning FI

circuit-breaker or protective earthing.
The energy cables which carry 230 V AC must not be disconnected from

the drive while the system is in operation.
Manipulated and/or non-functioning safety devices and safeguards!
Major risk of injury
Shut off the installation immediately.

Skilled personnel must remedy the fault or manipulation immediately.

Hazard caused by incorrect assembly and installation
Major risk of injury during live operation!
Assembly works and commissioning work may only be carried out

by employees at Bosch Rexroth or specialists instructed to do so.
This also applies when the product is returned to service after repair work.
Maintenance work must only be carried out by skilled workers.

Danger of crushing by the system!
Risk of injury!
Do not remove any safeguards (e.g. door switches, isolating elements)

Under no circumstances remove safety instructions or signage - make sure

they are installed.
Training system mMS 4.0 | R901429162/04.16
WARNING
WARNING