Bosch REXROTH mMS 4.0 Operating Manual page 49

Training system mMS 4.0 | R901429162/04.16
The remaining compressed air supply is transmitted from station to station.

Fig. 22: Compressed air connection between two stations
Setting the pressure reducer
Notice: The pressure reducer is set to a pressure of 6 bar at the factory.
If the pressure reducer needs to be re-adjusted, proceed as follows:
Pull the cap upwards.

Set the required pressure by turning the cap.

Press the cap downwards.

Do not adjust the system pressure! The pressure switch for the emergency stop
circuit is set to this 6 bar system pressure.
Bosch Rexroth AG
Set-up, installation and commissioning
49/68