Check Electric Installation - Bosch REXROTH mMS 4.0 Operating Manual

Training system mMS 4.0 | R901429162/04.16
Prerequisites
9.3

Check electric installation

To install the mMS 4.0 training system, it is required that
 Each station of the training system mMS 4.0 has been set up properly
(see chapter 9.1 Setting up the mMS 4.0 training system) and is complete,
 the correct connection voltage and fuse protection is available power supply
on the customer side,
 Work on the electrical equipment of the training system must be performed by
a specialist electrician only,
 no cables are damaged;
 The connection cables are installed in a way that prevents it from being
crushed, driven over, kinked, stressed or covered.
 The electrical control box cannot be opened and tampered with.
 No additional consumers are connected.
Check the electrical fuse protection is correct and sufficient.

Connect the mains plug to the first and last station to the power supply

of the customer-side socket (110-230V AC).
Connect each station with each other.

All other stations are supplied via the connecting cables.

The electrical supply of the mMS 4.0 training system is established.
The electro cabinet can be viewed in the enclosed CD.
The electric circuit diagrams of each station can be found in the enclosed
documentation CD.
Bosch Rexroth AG
Set-up, installation and commissioning
47/68