Set-Up, Installation And Commissioning; Setting Up The Mms 4.0 Training System - Bosch REXROTH mMS 4.0 Operating Manual

Training system mMS 4.0 | R901429162/04.16
Preparations for the set-up
9

Set-up, installation and commissioning

9.1

Setting up the mMS 4.0 training system

Risk of anomalies, deviations, faults, defects during set-up or inspection
Risk of damage!
Do not put the mMS 4.0 training system in operation or place it immediately

out of service.
Find the causes of the fault and fix the defect.

Replace the damaged part.

Perfect execution of the set-up requires that:
 delivery, transport or unpacking has been carried out properly as per chapter 7.2.2,
 all of the required parts are in range and in a functional condition,
 required auxiliary equipment, such as lifting tools, tables, are present.
Before the final set-up, please note the following points:
Make sure the required clearance for the mMS 4.0 training system and

the safety clearances to other fixed installations is present (for specifications,
see Fig. 1: Space requirement (in cm), ). Any possible attachment parts
should be taken into account.
Check the levelness of the installation surface.

Make sure that an electrical connection is present.

Make sure there is sufficient lighting at the place of installation.

Installation The following must be taken into account during installation:
Check alignment of the mMS 4.0 training system at the place of installation.

Lock the castors of the stations.

Connect each station with each other mechanically.

Also connect the electrical and pneumatic connections.

Bosch Rexroth AG
Set-up, installation and commissioning
NOTE
45/68