Quick Start - microHAM micro KEYER Manual

Insert CR-ROM to the CD drive
w
Run "urouter_release_xx_xx.exe" (xx_xx is version) from CD to start the installation and launch Router.
w
Connect USB cable to the micro KEYER. Other cables left unconnected
w
Plug second end of the USB cable to the computer USB port and install USB driver from location:
w
C:\Program Files\microHAM\driver\d2xx
You should see tab with micro KEYER statement with yellow X mark
w
Plug audio cables to the sound card and to the micro KEYER rear panel jacks. Computer Line Out to
w
micro KEYER Line Out, computer Line In to MK Line In and computer Mic In to MK Mic In.
Turn OFF your radio
w
Plug DB37 radio cable to the micro KEYER and other ends of the radio cable to the appropriate radio
w
jacks.
Turn radio ON.
w
Within three second you should see single flash of green FSK Led at the MK front panel and a few
w
seconds you should see Green OK mark at Router software next micro KEYER statement tab.
Congratulation ! You can start playing with micro KEYER, but better read this manual now :-)
w
microHAM © 2004 All rights reserved

4. QUICK START

6