The Water Tank - Blomberg TKF 1350 Operating Instructions Manual

Notes on the positioning of the
sponge filter
After cleaning, the sponge filter should be
reinserted without any squeezing.
Reinsertion should be done as indicated by
the arrow below.
Insert sponge filter without squeezing as
indicated below
Condenser- sponge filter
An optimal retention of fluff balls is nec-
essary for the regular operation of the
condenser dryer with heat pump. Improper
handling of the fluff and sponge filters will
impair the performance of the dryer and
cause damage.
In addition to the mentioned fluff and
sponge filters, the condenser- sponge
filter is employed. If fluff and sponge filter
are handled appropriately, the condenser-
sponge filter must be controlled and pos-
sibly cleaned approximately 3 to 4 times a
year.
Remove the condenser- sponge filter as
indicated on the picture below.
After removal of the condenser- sponge
filter, the metal grit structure of the heat
exchanger becomes visible.
The condenser- sponge filter must be
cleaned when covered with a layer of
fluff. For that purpose, wash the filter and
squeeze it until the sponge is only moist.
Important advice:
While reinserting the condenser sponge
filter, ensure that the filter is positioned
between the grit structure and the plastic
container without squeezing nor compres-
sion. Also make sure that the condenser
sponge filter is not reinserted skewed, i.e.
partly outside of the previewed slot.
Improper reinsertion of the condenser-
sponge will diminish the dryerʼs perfor-
mance and result in damages.
A spare sponge filter as well as a spare
condenser- sponge filter will be included in
the delivery of the appliance.
Please store these spare parts safely!
Clean the filter unit periodically:
A dirty heat pump requires more energy
and time for drying!
Under no circumstances, dry without hav-
ing inserted the sponge filter!

The water tank

During the drying process, the wet clothes
are deprived of water through vaporization.
The water vapor cools again (condenses),
and is caught in the water tank.
Empty the water tank:
• after the drying or
• if during drying the indicator "Empty tank"
flashes.
Important Advice
Do not pull the water tank while a program
is running.
You also can drain the water continuously
16