Table of Contents
Advertisement
Only authorised specialists are permit-
ted to carry out a built-under installa-
tion. Risk of electric shock!
Washer/dryer combination
This appliance can be put on top of any of
our washing machines.
• A special stacking kit is required (stock
no. MBS 2000), available at the cus-
tomer service or specialised trade.
Levelling
• Adjust feet until the appliance is level
and does not rock. Checking with a
spirit level is recommended.
Important:
• Adjust by the feet only, do not use
wooden wedges or similar. Never re-
move the feet!
Changing hinge position
If you wish to open the door to the other
side, you can have the hinge position
changed from left hand to right hand or
vice versa by our customer service.
Electrical connection
Connect the appliance to a properly in-
stalled earthed outlet, protected by a fuse
of adequate capacity.
Important:
• The connection must conform to the
applicable regulations in your country
and of your local Electricity Board.
• The power cable plug must be accessi-
ble after installation.
• For a firmly fixed connection a master
switch with at least 3 mm contact
clearance must be used.
• Voltage and fuse rating of the appli-
ance is stated on the rating label (on
the rear panel and behind the door).
•The current of the appliance can be
set according to the electrical
infrastructure and fuse rating of your area.
To change the current from 16 A to 10 A:
Set the programme selector to >One
piece<. Press the buzzer cancel button for
3 seconds. 16 will appear on the display.
Press - button, 10 will appear on display,
the appliance is set to 10 A.
To change the current from 10 A to 16 A:
Follow the same route, this time press + to
change it to 16 A.
Note down the appliance's model and
identification number from the rat-
ing label, in case you need help from
customer service.
• The stated voltage must match with
your mains voltage.
• Connection by extension cables or trail-
ing sockets is not permitted.
• When connecting to the mains, make
sure the On/Off button is in Off position.
A damaged power cable must be re-
placed by an authorised qualified elec-
trician. Until the appliance has been
repaired it must not be operated! Risk
of electric shock!
The first time
• To remove any possible residue from
production wipe out the drum with a
moist cloth before the first drying cycle.
• During the first drying cycle there may
be an annoyance caused by bad smell.
Before Drying
What can be dried
• The laundry should be spin-dried as
much as possible – to the extent per-
missible for the respective fabric.
Always observe the care symbols
shown on the garment labels!
Care symbols for drying
Suitable for drying at high
temperature:
Hot wash / coloured cottons,
cotton, linen
Suitable for drying at re-
duced temperature:
Easy-care synthetics (polyes-
ter, polyamide); mixed fabrics
(with cotton)
Drying in dryer not possible:
Sensitive fabrics (viscose, silk,
etc.); curtains
5
Hide quick links:
Advertisement
Table of Contents
