Table of Contents
Advertisement
MELCLOUD
4.
The LED display corresponds to that shown below when the connection has been established.
NOTE!
►It can take a few minutes for the following display to appear.
(If the display does not change, press RESET for longer than 10 seconds, e.g. 14 seconds, to start
setup again beginning with 4.1.)
LED
4.5
Setup WPS-PIN mode
1.
Before using WPS-PIN mode, the wi-fi adapter PIN has to be entered in the router.
Read the router instructions to learn how to enter the PIN.
2.
To set WPS-PIN mode, press MODE for longer than 10 seconds and then release the button.
3.
The LEDs NET and UNIT flash (every 5 seconds) when the connection has been made.
NOTE!
►Verify that the router supports WPS-PIN mode.
Not all routers support WPS-PIN mode.
►Press RESET for 2 seconds to reset the wi-fi adapter if the LED display has not changed after
5 minutes.
26 / Software information 2019
Flashes (every 5 seconds)
Flashes (every 5 seconds)
Connected
Connected
Hide quick links:
Advertisement
Table of Contents
