Setup In Wps-Push Mode - Mitsubishi Electric MELCloud Installation And Operation Manual

MELCLOUD
4.3

Setup in WPS-PUSH mode

1. Verify that the LED display corresponds to that shown below.
Press the WPS button on the router within 2 minutes of selecting the mode (section 4.2).
WPS-PUSH mode returns to the initial state (section 4.1) if the WPS button is not pressed within 2 minutes.
LED
2. The LED display corresponds to that shown below when the connection between the router and the wi-fi adapter has
been established and the connection to the MELCloud started.
Note: The LED display returns to the initial state if connection fails.
LED
3. The LED display corresponds to that shown below when the connection has been established.
Note: It can take a few minutes for the following display to appear.
LED
NOTE!
►The two most common reasons for faulty setup are:
1. Communication distance (from wi-fi adapter to router)
2. Router settings (encryption, authentication, limited number of connections, etc.)
24 / Software information 2019
Flashes (every second)
ON (5 sec.)
Flashes (every 5 seconds)
Flashes (every 5 seconds)
Connect
Router
Wi-fi interface
Connected
Connect
Connected
Connected