Mitsubishi Electric MELCloud Installation And Operation Manual page 21

Holder
Mark for cable
1. The cable from the wi-fi adapter
6
2. Mount the holder
3. Push the wi-fi adapter
NOTE!
►Tighten the upper and then the lower screw. Adjust the holder
align it.
MOUNTING TO THE EXTERIOR OF AN INDOOR UNIT
Holder
Clip
7
1. Push the clip into the holder
2. Push the wi-fi adapter
NOTE!
►Use caution to prevent the cable from being pinched when it is inserted into the holder.
7
3. Slide the clip towards the corner flap of the ATA/ATW or Lossnay unit to secure the wi-fi adapter
Screw fixed
Setting
Mark for
cable
1
should run down.
to the wall such that its mark for the cable points down.
1 6
into the holder until it clicks.
Holder
Mark for cable
Wi-fi adapter
Power cable
6
until it clicks.
1 6
into the holder until it clicks.
Holder
Wall
Screw
Wi-fi adapter
6
with the slot for the lower screw and
Corner flap
Align
MELCLOUD
Screw
Cable clamp
Power cable to secure
Wi-fi adapter
Clip
1
.
Software information 2019 / 21