Plug & Measure: Permissible Activities; Plug & Measure; Setting Instructions - Siemens SIPROCESS GA700 Quick Start Manual

3.4 Plug & Measure: Permissible activities
3.4.1 Plug & measure
Term
"Plug & Measure" is the ability to recognize any analyzer modules and/or option modules added
at a later time and to integrate them. This ability makes it easier to replace modules for
maintenance purposes as well as installing devices at a later time, for example, option modules.
When you replace or retrofit a module, the processing unit recognizes the change in the device
configuration during a restart. The type of module as well as its parameter assignment are
recognized. You have the option to apply the parameter assignment of the replacement/retrofit
module or to use the one of the previous module.
See also
Plug & Measure: Permissible activities (Page 33)
Case differentiations (Page 34)
3.4.2

Setting instructions

NOTICE
Damage caused by inadmissible procedure/faulty operations
Inadmissible procedure and/or faulty operations can result in damage to the device or its
modules/electrical equipment in connection with Plug & Measure. Therefore:
● Observe the specifications regarding installation/removal of the device hardware.
● Carefully read the following information on different Plug & Measure cases.
NOTICE
Damage to the analyzer module electronics due to faulty operation during commissioning
During commissioning after replacement of the AM electronics, a faulty operation can prevent
transfer of the parameters and render the AM electronics unusable. When you commission
the device once again after replacing the AM electronics, the following applies:
● First, confirm the message regarding change of the configuration
● Make sure to confirm the transfer of the parameters by pressing <ENTER>
Quick Start
Compact Operating Instructions, 05/2015, A5E31805656-03
Combination operation
3.4 Plug & Measure: Permissible activities
33