Toro Reelmaster 3100-D Operator's Manual page 24

Figure 33
1. Throttle
2. Hour meter
3. Temperature light
4. Oil-pressure light
5. Glow-plug indicator light
6. Alternator light
Throttle
Move the throttle (Figure
engine speed and rearward to decrease the engine
speed.
Cutting Unit Drive Switch
The cutting unit drive switch
positions: E and D
NGAGE
operates a solenoid valve on the valve bank to drive
the cutting units.
Hour Meter
The hour meter (Figure
machine operation. The hour meter starts to function
whenever the key switch is on.
Cutting Unit Shift Lever
To lower the cutting units to the ground, move the
cutting unit shift lever (Figure
units do not drop unless the engine is running, and
they do not operate in the raised position. To raise
the cutting units, pull the shift lever rearward to the
R position.
AISE
Move the lever to the right or left to move the cutting
units in the same direction. This should only be done
when the cutting units are raised or if they are on the
ground and the machine is moving (Model 03171
only).
Note:
The lever does not have to be held in the
forward position while the cutting units are lowered.
7. Cutting-unit drive switch
8. Cutting-unit shift lever
9. Ignition switch
10. Parking brake
11. Lift lever lock
33) forward to increase the
(Figure 33) has 2
. The rocker switch
ISENGAGE
33) indicates the total hours of
33) forward. The cutting
DANGER
Shifting the cutting units downhill decreases
machine stability. This could cause a rollover,
which may result in personal injury or death.
Shift the cutting units uphill while on a side
hill.
Engine Coolant Temperature
Warning Light
The temperature warning light
g191213
engine coolant temperature is high. If you do not stop
the traction unit and the coolant temperature rises
another 5.5°C (10°F), the engine shuts off.
Oil Pressure Warning Light
The oil pressure warning light
engine oil pressure drops below a safe level.
Alternator Light
The alternator light
the engine is running. If it is on, check and repair the
charging system as needed.
Glow Plug Indicator
The glow plug indicator light
the glow plugs are operating.
Parking Brake
Whenever the engine is shut off, engage the parking
brake (Figure 33) to prevent accidental movement of
the machine. To engage the parking brake, pull up on
the lever. The engine stops if you press the traction
pedal with the parking brake engaged.
Lift Lever Lock
Move the lift lever lock
the cutting units from dropping.
Reel Speed Control
The reel speed control is located under the console
cover (Figure 34). To attain the desired clip rate (reel
speed), rotate the reel speed control knob to the
appropriate height-of-cut setting and mower speed.
Refer to Clip Rate (Reel Speed) (page
24
(Figure 33) glows if the
(Figure 33) glows if the
(Figure 33) should be off when
(Figure 33) glows when
(Figure 33) rearward to prevent
30).